Thermo Control PRO II Day/Night Thermostat

Thermo Control PRO II thermostat

• 2 temperature switching circuits for difference between day and night settings
• timer times are indicated according to standard time
• integrated timer
• the measured temperature is displayed
• switching between heating and cooling is possible
• alarm function in case of temperature deviations (adjustable between 1 and 15 degrees)
• 3 m. long distance sensor, also suitable for aquariums
• 1000 watts

Recommended for the use of heating mats, heating cables, heating stones and ceramic heating devices, to prevent heating in the terrarium.

The popular Thermo Control PRO II has been under revision and is now equipped with new functions! The device now features 4 – instead of previously 2 - time zones, that can be programmed with a certain temperature. Thanks to the temperature time zones, which allow increasing and lowering the temperature in several steps rather than abrupt, the daily temperature development can be virtually like in nature. The user has full control, because everything is set and controlled by a timer. Another novelty is the possibility to set temperatures in 0,1 ° C increments. For technical reasons, the hysteresis cannot be set below 0,5 ° C though.

Additional features:

The additional features of the Thermo Control PRO II have of course also been improved. Instead of 2 settings for the timer now up to 8 On/Off settings are possible. The acoustic alarm can now be turned off independently and a min/max function has been added showing the min/max temperature values of the day (automatic reset at midnight). Behind the scenes the control of the relays has been improved and every relay is now protected by a changeable fuse which reduces the risk of damage by a short circuit, like it may happen in case of a failure of halogen lamps. Of course the proven features, such as the real-time clock, the constant temperature display and the ability to switch between heating and cooling mode, e.g. to use fans are also included in the new model. In cooling mode the device switches after a 3 minute delay, in order that compressor cooling technology or an aquarium chiller can be used. The max load remains at 1000W as well as the temperature range of 0-50°C and the two meter long, waterproof temperature sensor that enables the use of the Thermo Control PRO II in aquariums. With its four temperature time zones, a minimum hysteresis of 0,5 ° C as well as all the functions, such as timer and constant temperature display with min / max storage, the Thermo Control PRO II stands out from the mass of the controllers on the market and is our clear recommendation for temperature control in terrariums and aquariums.

Thermo Control Pro II terms of use:

• The Thermo Control Pro II thermostat may only be connected to a network with 230V / 50 / 60Hz alternating voltage.
• The position of the device during use doesn't matter. However, the device must be placed in such a way that it cannot fall into water!
• The permissible ambient temperature must not fall below 0 ° C or exceed 60 ° C during operation.
• The device is designed for use in dry and clean rooms.
• If condensation water is formed, an acclimatization time of up to 2 hours must be awaited.
• Protect the device against moisture, splash water and the influence of heat!